Remove the six 7mm Phillips #1 screws attatching the Zipconnect unit to the motherboard wire and set the unit out of the way. The Zipconnect unit will lift out but will still be attached by a wire connected to the motherboard. Turn the device over again so you are looking at the internals. Remove the three 7mm Phillips #1 screws connecting the Zipconnect unit. Turn the device over so that the internals are facing down. Lay the device down, so that all the internal components are facing upwards. Grip either side of the top round part of the case and carefully open the device to reveal all the hidden treasures inside! Do not separate by more than 1 centimeter. The bottom of the two halves are connected by the speaker wire. Grip both sides of the top round part of the case and carefully open it like a clam. They are held together by the speaker wire. A small gap will open as the two tabs are released. With your thumbs on either side of the grey label, slowly push with both thumbs until the case pops open. Once you remove the screws, pick the device up so that the grey label on the bottom of the device faces toward you. Be careful! There are two small, easily-broken, plastic tabs at the bottom of the device keeping it together. Remove the four 12mm phillips head #2 screws located along the outer edge of the white case. Unplug the power cord from the "DC Input." Gently position the device so that the buttons and speakers lie face down.
TOOLS: Phillips #1 Screwdriver (1) Phillips #2 Screwdriver (1) The dial is located on the back of the device on the same side as the inputs.
INTRODUCTION This guide will demonstrate the replacement of the light intensity dial which controls the brightness of the LED lights. Sharper Image iPulse SI325 Light Intensity Dial Replacement Use this guide to replace the light intensity dial. Sharper Image iPulse SI325 Light Intensity Dial Replacement
0 kommentar(er)
